Cable Drop Through Attic

Pull them up into the attic and then push them down to the distribution box.

Cable drop through attic.

Raul no this is not a standard practice and is most likely the result of improper installation of electrical attic wiring. Hole drilled through the plates from the attic then tape both of the marked cable ends to the fish tape. Mark the ends of the cables with colored electrical tape for the outlet location. When adding or replacing wiring in finished walls most electricians will attempt to make the horizontal portion of the cable run in the unfinished attic or basement crawlspace areas looping the cable down or up through the wall cavity across the floor or ceiling joists then vertically through another stud cavity to the next wall box opening.

For the horizontal portion of the cable run this can involve drilling holes in the joists where the cable will pass. Yes this should be corrected and it would be good to have the wiring and all the circuit connections inspected as well. Depending on what the wiring is for this may be go through the drywall to the ceiling for instance for new lighting or be farther down on a wall. I traced down the cable tv through that attic and then drilled new holes in the top plate right next to the cable tv holes.

The attic wiring should be protected and secured to ceiling joists or other wood structural supports. Cut the holes that the wire will pass through to enter and exit the attic. You ll need a powerful drill and either a paddle bit or a hole saw for. From inside the living space position the bit against the wall directly above if accessing from attic or below if accessing from basement the desired location of the service the cable will provide.